Sandvik 20C for pad printing applications (Strip steel)
Datasheet updated 2012-11-01 16:46:34 (supersedes all previous editions)
Sandvik 20C is a hardened and tempered carbon steel used for pad printing applications. The grade is characterized by:
- Excellent surface finish
- Good flatness
- Good etchability
- High strength and wear resistance
- Low level of non-metallic inclusions
- Good dimensional tolerances
- ASTM 1095
- EN number 1.1274
Forms of supply
Strip steel is supplied in labelled coils. The label details the steel grade; heat, lot and coil number; and nominal size, allowing full material traceability.
Material is protected against rust with oil. Coils are packed in wooden cases. For overseas shipment, coils are wrapped in paper and sealed in a plastic bag containing silica gel. Net and gross weights are marked on the case. Customized properties, dimensions and tolerances can be supplied on request.
Sandvik 20C is supplied in standard thicknesses in accordance with the table below.
Material with closer tolerances can be supplied on request.
Strip in standard thicknesses is stocked in widths up to 320-340 mm (12.6-13.39 in.), ready for slitting to the required width.
Edges are slit and deburred.
Maximum out-of-flatness across and along the strip is 0.30% of the nominal strip width.
Material is delivered white polished, free from oxide discoloration and with uniform colour and dust free.
Maximum surface roughness values, cut-off 0.25 mm (.0098 in.), are shown in the table below.
A small number of surface defects, such as pits and roll marks, with a depth or height of up to 5 µm (200 µin.) maximum is allowed. The maximum scratch depth allowed is 2.0 µm (80 µin.).
Out-of-straightness is defined as the maximum deviation from a straight-edge of specified length. The following values apply:
|Strip width||Maximum allowed deviation|
Strip can be supplied with closer straightness values on request.
Also stainless steel in Sandvik grade 7C27Mo2 can be supplied for the application pad printing. For further information about the stainless alternative please contact Product area Strip, department for H/T Precision Strip.
The yield strength, Rp0.2, is approximately 90% of the tensile strength, Rm. The manufacturing tolerance for tensile strength is ±80 MPa (±11.6 ksi).
Disclaimer: Recommendations are for guidance only, and the suitability of a material for a specific application can be confirmed only when we know the actual service conditions. Continuous development may necessitate changes in technical data without notice. This datasheet is only valid for Sandvik materials.